Turtle Moxa Device - Small

For further instructions on how to use the moxa cones and device, please click on the link below:

https://www.youtube.com/watch?v=GPGvUC32tnQ

CAUTIONS:

1. Cover skin with thin fabric or clothing. Do not use on bare skin.

2. Do not use on the face, soft skin, or other sensitive body parts. Do not use on pregnant women or patients who are unable to detect the sensations of heat or pain.

3. If device is used incorrectly, redness or heat blisters may appear after application. Do not leave in one place for an extended period of time.  If the heat becomes uncomfortable, remove immediately.

4. Use in a well-ventilated area.

5. Moxa device and moxa should be administered and used under the direction or supervision of a qualified practitioner. Do not leave patient unattended during any moxa use.

6. Be cautious when touching the moxa device - may cause burns. Please use handles.

7. Keep moxa device out of reach of children.

8. DO NOT fall asleep during moxibustion to prevent possible burns or fires.

9. Dispose of remaining ash in a non-flammable area. 

**Moxa device is extremely hot and can cause burns. Be cautious of possible burns or fires that may occur while using. Handle with extreme care. The user/purchaser accepts full responsibility for any burns or accidents caused by improper use of the product. **

INSTRUCTIONS:

 1. IGNITION

STEP 1) Place the moxa cone in the moxa device.

STEP 2) Use a torch to ignite the top center of the moxa cone. Ignition takes approximately 15~20 seconds.

STEP 3) After igniting, gently blow on moxa to ensure moxa ignites fully and evenly. If moxa is properly ignited, the top center of the moxa cone will form a glowing, red circle. 

2. INSTALLATION

STEP 1) Once the ignition is completed, place the lid on the base and lock the device with the silicone safety band.

STEP 2) User may leave the device outside for several minutes to eliminate any excessive odor. 

HOW TO USE SILICONE SAFETY BAND

STEP 1) Lay out silicone safety bands and inspect for any rips or tears before use. If safety bands have rips or visible tears, replace with new bands before using moxa device.

STEP 2) Place one band over the top of the device and stretch over the opposing side of the device handle as shown in the diagram.

STEP 3) Ensure band is on the handle fully and securely.

STEP 4) Secure the second safety band over the opposite side of the device and handle. 

STEP 5) Ensure both safety bands are fully and securely over handles before placing the moxa device on the desired treatment area. 

DEVICE MAINTENANCE

Frequent cleanup is not required. Device should be cleaned once a year or every two years. In case of excessive soot buildup, boil for 20 minutes and clean with a brush. Boil ONLY in case of excessive soot buildup (Unnecessary boiling may damage the device).

Keep the lid tightly closed and store in a dry area after use.