KS-9800N: TDP Far Infrared Mineral Heat Lamp w/ Detachable Head Standing Model(FREE SHIPPING)

More Views

KS-9800N: TDP Far Infrared Mineral Heat Lamp w/ Detachable Head Standing Model(FREE SHIPPING)

Be the first to review this product

$134.99

Availability: In stock

Short Description

FREE SHIPPING

The lamp is equipped with an anti-tilt switch to comply with mandatory safety requirements. The lamp will operate only when in an upright (vertical) position and will NOT turn on if tilted or placed horizontally (laid flat). For safety reasons, the anti-tilt switch is designed to automatically cut off power when the lamp is tilted, tipped over, or improperly positioned.

The heating tube does not glow in a full circle. It glows only in its U-shaped (horseshoe) form, which is normal.

Features a red heating tube, producing visible red light, combined with a mineral plate that emits far-infrared waves ranging from 2–25 µm, corresponding to the classic TDP lamp spectrum.

Technical Specification of TDP Lamp

Hz (Hertz) 50 Hz
Spectrum Range 5-25 microns
Power 110 V, 220 watts
Elevation Degree > 90
Azimuth Degree 360
Life of Mineral Plate 1000 Hours
Shining Distance > 8” (20cm)
Oversized Mineral Plate 6.5” Dia. (Reg. size Plate 5” Dia.)

6 Months Limited Warranty on Control Panel and Labor
3 Months Limited Warranty on accessory parts

Video 1 - How to assemble the full TDP lamp start to finish:
https://youtube.com/shorts/8jRP0gPLI5w?si=4P73BhivVlwVphls

Video 2 - How to assemble the TDP head to the TDP lamp easily and less than 2 mins:
https://youtube.com/shorts/ksP-neKIXMM?si=0GOV-9K1x889A__g

**Free shipping may not be reflected at the time of checkout, but the invoice will be adjusted on our end before the order is charged to your credeit card**

Qty:

Description

Details

KS-9800 vs KS-9800N Comparison

KS-9800N

IMPORTANT: DO NOT USE ON BARE SKIN. Please make sure to wear light clothing during use to prevent burns. Please consult your doctor before use.

1) The heat lamp will take approximately 5 minutes to heat up.
2) As a general guideline, maintain a distance of approximately 8-10 inches (or more) between the treatment surface and heating head. Actual positioning of the TDP head may be adjusted to reach the desired level of heat. Do not position the lamp head too close to the skin.
3) A typical treatment session should last approximately 20 to 40 minutes. The exact duration may vary depending on the specific condition.
4) The heat lamp only provides warmth for therapeutic heat treatments. Please do not expect a higher temperature range as higher temperatures may cause the skin to overheat and burn. Higher temperature ranges will not increase the effectiveness of the treatment.